ELEKTRA Crema Caffe, Instruction Manual

Page: 39 / 68

39
10
11
12
13
WARNING: NO WATER IN THE BOILER (A-S-C-B)
If the following alert appears (A):
“NO WATER IN THE BOILER - MACHINE OFF - REPAIR FAULT AND RESET HEATING ELEMENT
SAFETY DEVICE WITH PROGRAMMING KEY”
or the following (S-C-B):
Due to the (even temporary) lack of water in the boiler the heating element safety device
may have been disactivated.
The heating element safety device can be resetted through the Basic Programming
(See chapter “C - ADJUSTMENTS”, paragraphs 1.4 or 2.11), after the reason for the lack
of water in the boiler has been eliminated or repaired .
Contact Technical Assistance.
WARNING: BREWING WATER TEMPERATURE CONTROL SYSTEM FAULT
(A-S-K-C-B)
If the following alert appears (A-K):
“BREWING WATER TEMPERATURE CONTROL SYSTEM FAULT - MACHINE OFF - REPAIR”
or the following (S-C-B):
a major fault has occurred.
Switch off the machine and contact Technical Assistance .
ONE DISPENSING GROUP DOES NOT HEAT SUFFICIENTLY
(A-S-K-C-B)
There is an obstruction to the passage of the brewing water, i.e.:
- Gigleur protection filter clogged.
- Group natural heating circuit clogged with scale deposits.
Contact Technical Assistance.
THE GAUGE SHOWS A BOILER PRESSURE NOT
BETWEEN 0.6 AND 1.6 BAR (S-C-B)
Unless this value exceeds 0.18 MPa (1.8 bar), in which case switch off the machine
and contact Technical Assistance, this is a fault that does not negatively affect the use
of the machine.
The most likely cause is related to calibration problems with the pressure gauge.
Contact Technical Assistance.