ELEKTRA Crema Caffe, Instruction Manual

Page: 38 / 68

38
WARNING OF NOT SATISFACTORY BREWING AND FLASHING
OF THE DISPENSING PUSHBUTTON LED (A-K)
If, after dispensing selected with an automatic button, e.g. group 1 single short coffee,
both the following alerts are displayed:
“BREWING NOT SATISFACTORY - CHECK COFFEE TAMPING OR DOSING OR GRINDING”
the coffee may not have been made according to Italian espresso standards,
and therefore adjustments in tamping, dosing or grinding of the coffee powder are required.
Perhaps even adjustments to temperature or brewing pressure are required (also consult
chapters “C - ADJUSTMENTS”, paragraphs 1.3, 2.6, 3, and “A - USE”, paragraph 10).
Alternatively, there might be a fault due to:
-
Water supply stoppage (except for A-K models with WTS): restore it.
- Fault or obstruction to the passing of water through some parts of the machine:
contact Technical Assistance.
WATER DOES NOT COME OUT OF A DISPENSING GROUP WHEN
THE MANUAL BUTTON IS USED (A-S-K-C-B)
The possible causes of this are:
-
Coffee ground too finely: adjust it.
- Water supply stoppage (except for A-K models with WTS): restore it.
- Fault or obstruction to the passing of water through some parts of the machine:
contact Technical Assistance.
ONE DISPENSING GROUP STARTS UP ON ITS OWN (B)
The membrane pushbutton panel has a damaged key or water has entered it.
- Identify the faulty key and, by switching it off and on repeatedly, try to disable
it and do not use it any more.
- Make the water inside the membrane evaporate by drying it with a hair dryer.
In the meantime, contact Technical Assistance.
WARNING: INADEQUATE WATER SUPPLY PRESSURE (A-K with WTS)
If the following alert appears on the display:
“INADEQUATE WATER SUPPLY PRESSURE - MACHINE OFF”,
the machine has suspended all of its functions in order to prevent damage to the pump
and other parts.
The possible causes of this are:
- Inadequate water supply pressure: restore it; the machine will resume operation
automatically.
- The water supply pressure is satisfactory but there is a fault in the water treatment
hydraulic circuit: switch off the machine and contact Technical Assistance .
6
7
8
9