-20-
Section 7 - Operating Instructions - quick guide
Please read the full operating instructions before starting, however below is a quick overview of the most
commonly used functions.
During an alarm or fault condition all sounders, beacons and internal buzzers can be turned off by pressing the
button. You will be asked to enter a password which is factory set at “AAAAAA”. As this is the default
password just pressing enter is sufficient. Once the password has been entered press the
button once
more.
Pressing mute does not stop any customer configured delayed outputs from operating. If the right hand DEL
lamp under the panel / device status heading is illuminated one or more (maximum of 8) of the customer
configured delayed outputs are due to operate. Pressing the
button will stop the delayed outputs
from operating, however if the fire or gas alarm condition returns the count down for the delayed output will start
again. If the alarm cannot be rectified before the delayed output operates, once operated it can be turned off by
pressing the
button.
If the right hand DEL lamp under the panel / device status heading is illuminated one or more (maximum of 8) of
the customer configured delayed outputs are due to operate. Pressing the
button will stop the
delayed outputs from operating, however if the fire or gas alarm condition returns the count down for the
delayed output will start again. If the alarm cannot be rectified quickly enough the delayed output, once
operated, can be turned off by pressing the
button. One or all of the delay times can be reduced to
zero from menu item number 6 in the systems main menu. Use the +/- keys to toggle between “normal” and “no
delay”. Use the arrow keys to choose which delay to change or choose global to change all.
After an alarm or fault condition has been rectified the system should be reset. Pressing the
button
will return the system to the normal state. You will be asked to enter a password which is factory set at
“AAAAAA”. As this is the default password just pressing enter is sufficient. Once the password has been
entered press the
button once more.
To operate all sounders, beacons, alarm relay and pre-alarm relay press the
button. You will be asked
to enter a password which is factory set at “AAAAAA”. As this is the default password just pressing enter is
sufficient. Once the password has been entered press the
button once more.
Silencing sounders, beacons and internal buzzers (MUTE)
Delayed outputs
System Reset
Evacuate
“MUTE”
“MUTE”
“RESET”
“MUTE”
“RESET”
“MUTE”
“RESET”
“RESET”
“EVAC”
“EVAC”
ED816A Addressable Fire and gas detection Installation manual 8-9-08 Rev-a
