Electrolux thermaline S90, Installation And Operating Instructions Manual

Page: 20 / 66

INSTALLATION INSTRUCTIONS
Seite 16 62.9582.01
1.5 STEEL PLINTH
To assemble the plinth you will need:
•
Right and left side plinth (1 / Fig.3).
• Plinth for the front and, for free-standing appliances, for the
rear also (2 / Fig.3).
D
Push the side plinth (1 / Fig.3) onto the legs from front to
rear using the fastener. The larger gap (b / Fig.3) on the
fastener must be at the bottom.
D
Affix the fasteners (3 / Fig.3) to the plinth (2 / Fig.3).
D
The larger gap (b / Fig.3) on the fastener must be at the
bottom.
D
Attach the plinth with the fasteners (3 / Fig.3) onto the feet.
1.6 WALL ASSEMBLY
The assembly kit for mounting the appliance to a wall contains:
2 fastening angles (1 / Fig.4), 4 screws with nuts, washers and
plugs (2 / Fig.4) to attach the appliance to the wall and
6 jackscrews with nuts (3 / Fig.4).
Assembling the fastening angles:
D
Mount the screws (2) into the wall, attach the two fastening
angles (1) and align them.
D
For each fastening angle (1), use two jackscrews (3a-c)
above and one below.
Jackscrews 3c:
• use the left thread for the left fastening angle,
• use the right thread for the right fastening angle.
Mounting the appliance:
D
Remove the base of the appliance.
D
Lift the appliance onto the spars (4) in the upper part of the
fastening angle.
D
Tighten the screws (3a) until the appliance is almost touch-
ing the wall.
Fine adjustments:
D
Use the jackscrews (3) to move the appliance into the cor-
rect position.
D
Fit the base of the appliance on again.
2. ACCESS TO INTERIOR
2.1 FRONT PANELS (A) and (B)
D
Unscrew screws (1 or 3). Also, in the case of a built-in oven,
unscrew screws (2 and/or 4) on the inside of the oven.
D
Pull the panel away forwards and downwards.
a
b
Fig. 3 Plinth assembly
Fig.4 Wall assembly
1
()
(5)
(4)
(1)
(2)
(3)
b
b
1
(3c)
(1)
(2)
(3)
(1)
(2)
(2)
(3b)
(3a)
(3c)
1
(4)
1
(3c)
Fig. 5 General view
Fig.6 Front panel
1 1
2
3 3
4
5 5
D
D
B
C
A
E
(1)