Electrolux EILFU17GS, Technical & Service Manual

Page: 46 / 96

5-6
C Co om mp po on ne en ntt T Te ea arrd do ow wn n
Figure 5-11. Door Switch Removal
Figure 5-12. Upper Shelf Assembly Removal
D Do oo orr S Sh he ellff G Gu ua arrd d R Re em mo ov va all
The door shelf guard is secured to the inner door
panel with two tabs on each end.
To remove the door shelf guard, bend the door
shelf guard out in the middle and pull the tabs out
of the inner panel. (See Figure 5-10)
D Do oo orr S Sw wiittc ch h R Re em mo ov va all
The door switch is mounted inside a hole in the
cabinet base along the lower left hand side.
(See Figure 5-11)
To remove the door switch:
1. Remove kickplate.
2. Reach into the access hole next to the door
switch and disconnect the electrical leads from
the door switch terminals.
3. Press in on the retaining latch on the switch
body and push switch through hole in cabinet
base.
IIn ntte erriio orr C Co om mp po on ne en ntts s
U Up pp pe err S Sh he ellff A As ss se em mb blly y
The upper glass shelf assemblies have metal bars
that slide into holes in the cabinet interior
sidewalls. The pizza shelf will fit on any of the
three upper glass shelves. (See Figure 5-12)
To remove the upper glass shelf assemblies:
1. If the pizza shelf is attached, remove first by
supporting the center of the shelf with one
hand and using the other hand to ease the
support tabs outward until the tabs drop
between the liner wall and the edge of the
shelf. Remove pizza shelf from unit.
2. Remove the glass shelves by pushing to the
right until the metal bars are free from the left
side liner wall. Then tilt down or up until the
shelf can be removed from the right side liner
wall.
Figure 5-10. Door Shelf Guard Removal
Door Shelf Guard
Door Switch
Locating
Holes in
Liner Wall
Access Hole
Bend Here
Glass Shelf
Pizza Shelf
Tabs