Electrolux EFLS417SIW, Technical & Service Manual

Page: 57 / 58

57
This is an excessive detergent dosage warning. The system detected too much foam was forming during the
drain phases. Advise the Customer to use the correct quantity of detergent and to make sure the filter and drain
circuit are clean.
EF2 EF2: Too Much Soap or Wrong Type EF2
Checks to perform:
EF5 EF5: Load Unbalanced EF5
Checks to perform:
WARNING
Check that all the connectors are correctly
inserted.
WARNING
Check that all the connectors are correctly
inserted.
Check if the power supply is as per the
product specifications?
Make the laundry as per the product specifications and
repeat the diagnostic cycle to check for any further errors.
Check whether the friction is caused by the motor (See
Fig. 2). Check whether the friction is caused by the tub
bearing (See Fig. 3). Replace the defective component. After
clearing any obstacles, wait till the motor becomes cool as
the thermal protector may take 30 mins to reset (thermal
protector may be tripped because of motor overheating).
Repeat the diagnostic cycle to check for any further errors.
Remove the laundry, and check whether
the drum turns freely without posing any
resistance. Is the drum having difficulty in
rotating? (See Fig. 1)
Y
E
S
NO
Provide required power supply, and repeat the diagnostic
cycle to check for any further errors.
Check if there is overload of laundry in
Washer?
YES
N
O
YES
Replace the Motor Control Board, and
repeat the diagnostic cycle to check for
any further errors.
N
O
Troubleshooting Based on Error Codes