Electrolux EFLS417SIW, Technical & Service Manual

Page: 37 / 58

37
E13
E13: Water Leak in Tub or in Pressure Sensor
E13
Maximum overall water fill time exceeded (sum of all water fills between one
drain phase and the next to avoid exceeding the maximum volume).
Checks to perform:
Check if the air tube is connected properly without
kinking and leaking? (Disconnect the tubes, and blow
into them to make sure the system is unobstructed).
(See Fig. 1)
Replace / Repair the air tube, and repeat the
diagnostic cycle to check for any further errors.
Is the frequency of Pressure Sensor between 44.5 Hz
and 45 Hz? (Measure it on the Pressure Sensor wiring
connector at Main Control Board when machine is
powered with empty tub (No water).) (See Fig. 2)
Replace Pressure Sensor, and repeat the
diagnostic cycle to check for any further errors.
Replace the Main Control Board, and repeat the
diagnostic cycle to check for any further errors.
Y
E
S
YES
Check for leakage in Washer. Is the Washer leaking
water?
Repair water leak, and repeat the diagnostic
cycle to check for any further errors.
NO
WARNING
Check that all the connectors are correctly
inserted.
N
O
Troubleshooting Based on Error Codes
Y
E
S
NO
Is drain hose 8” or less into stand pipe?
Y
E
S
NO
Adjust it.