53
Maintenance, inspections, checks and cleaning
Frequency
Responsibility
Control
• check and clean the discharge system.
Every 6 months
Service
General machine overhaul
• check all components, electrical equipment, corrosion, pipes…
Every 10 years
2
Service
1.
In particular conditions (e. g. intensive use of the appliance, salty environment, etc.) the preventive maintenance should be more frequent.
2.
the machine is designed and built for a duration of about 10 years. After this period of time (from commissioning) the machine must undergo a general
inspection and overhaul. Some examples of checks to be carried out are given below.
• Check for any oxidised electrical components or parts; if necessary, replace them and restore the initial conditions;
• Check the structure and welded joints in particular;
• Check and replace bolts and/or screws, also checking for any loose components;
• Check the electrical and electronic system;
• Check the functionality of safety devices;
• Check the general condition of protection devices and guards.
NOTE!
It is advisable to stipulate a preventive and scheduled maintenance contract with the Customer Care Service.
Disassembly
• All scrapping operations must occur with the machine stopped and cold and the electrical power supply disconnected;
• Work on the electrical equipment must only be carried out by a qualified electrician, with the power supply disconnected;
• To carry out these operations it is necessary to use: overalls, safety shoes and gloves;
• During disassembly and handling of the various parts, the minimum height from the floor must be maintained.
G
TROUBLESHOOTING
G.1
Anomaly table
In case of anomaly, the oven always displays a warning message or alarm describing the occurring fault. The corresponding icon
remain visible until the problem is resolved.
Warnings icon
Alarms signalling icon
Follow the indications given by the appliance and, if required, contact the Customer Care Service remembering to:
1. disconnect the appliance from the main power supply;
2. switch off the safety circuit breaker ahead of the appliance;
3. close the gas (in case of gas models) and water taps;
In some cases, faults can be eliminated easily and quickly by following the indication of this troubleshooting guide:
Anom-
aly
Type of
anomaly
Description
Possible causes
Actions
ACF
Warning
Air filter absent
• Filter not detected;
• Possible damage to
internal electric and
electronic components
due to air filter absence.
• Refit the filter;
• If the problem persists call Service.
ACUM
Stops
oven
Main electronic board
not identified
Communication problem
with the main electronic
board.
• Switch the oven OFF/ON;
• If the error persists, call Service.
ASCH
Warning
Component compart-
ment temperature
warning
• Filter is dirty;
• Too high room
temperature.
• Check room temperature considering the
oven needs fresh air to cool electronic
compartment.
• Clean the filter;
• Allow oven to cool before cooking;
• If the problem persists, call Service
BEtc
Stops
cleaning
Error, excessive time
on closing operation
during cleaning
Mechanical or electrical
problem with vent valve.
Call Service
BEto
Stops
cleaning
Error, excessive time
on opening operation
during cleaning
Mechanical or electrical
problem with vent valve.
Call Service
!