Electrolux Built-In Dishwasher, Service Manual

Page: 54 / 65

54 5995432258
Diagnostic Mode
1. To enter the diagnostic mode, the temperature display
must be lit up. If the temperature display is not lit, press
any pad on the overlay.
2. Press the 2 COLDER and 2 WARMER pads
simultaneously for three seconds. The FREEZER and
REFRIGERATOR displays will change to 0 0 .
3. To select a test mode:
a. Enter a numeric value (see Test Mode
Char t) on the FREEZER display using
the COLDER or WARMER pad.
Note: The COLDER pad decreases the numeric value.
The WARMER pad increases the numeric value.
b. Enter a numeric value (see Test Mode Char t)
on the REFRIGERATOR display using
the COLDER or WARMER pad.
4. Once the displays indicate a test mode, press any pad
Service Diagnostics
on the temperature board overlay, other than the
COLDER or WARMER pads, to enter that mode.
Note: A test mode must be selected within 30 seconds of
entering the diagnostic mode or it will time out, normal
refrigerator operation will resume, and the displays will
turn off. Once a test mode is selected, the display will
flash to confirm the mode selected.
5. At the end of a test session, to exit the diagnostic mode,
do one of the following:
• Enter 1 on the FREEZER display and 5 on
the REFRIGERATOR display. Press any pad
other than the COLDER or WARMER pads to
e xecute a system restart.
• Enter
1 on the FREEZER display and 6 on
the REFRIGERATOR display. Press any pad
other than the COLDER or WARMER pads to
exit the service diagnostic test mode.
• Recycle power to the unit through the
main switch. As a cautionary measure,
the system will automatically time out of
the diagnostic mode after 15 minutes of
inactivity. In the diagnostics mode, the unit
can be tested under different conditions.