Electrolux Built-In Dishwasher, Service Manual

Page: 11 / 65

11
5995432258
Quick Ice
When you need ice in a hurry,
press this button to speed up ice
production. This will increase ice
production for the following
48 hours or until you press the
button again.
Dispenser Light
This button turns the night light
on the dispenser on and off.
The light also comes on when
the dispenser pad is pressed. If
this light burns out, it should be
replaced with a 6 watt 12V
maximum bulb.
Door Alarm
To turn the Door Alarm on, press
the
DOOR ALARM button once.
The ACTIVE light will come on.
To turn it off, press it again.
When the
DOOR ALARM is
active, the ACTIVE light will
flash if you open the door and
beep if you keep the door open
for more than 2 minutes. The
light goes out and the beeping
stops when you close the door.
Spill Shelf
Note: When Q
UICK
I
CE
is selected, the freezer
temperature operates at -9°F for 48 hours or until
QUICK
ICE
is pressed again. There is no change of temperature on
the display panel. In the event of a power loss, if the
freezer temperature is above 40°F, Quick Ice will not
restart. Below 40°F, the refrigerator will return to
the Quick Ice mode
.
To Use the Dispenser
Select CUBED , CRUSHED or WATER . Press the glass
gently against the middle of the dispenser pad. The spill shelf
is not self-draining.To reduce water spotting, the shelf and
its grille should be cleaned regularly.
If no water is dispensed when the refrigerator is first
installed, there may be air in the water line system. Press
the dispenser arm for at least two minutes to
remove trapped air from the water line and to fill the water
system. To flush out impurities in the water line, throw
away the first six glassfuls of water.
CAUTION:
Never put fingers or any other objects into the ice crusher
discharge opening.
Locking the Dispenser
Press the LOCK/LIGHT
button for 3 seconds to lock the
dispenser and control panel. To
unlock, press and hold the button
again for 3 seconds.
Display after power failure:
After a power failure, the
display will reset based
on freezer temperature.
If the freezer temperature
is below 40°F, the display
will retain the settings
prior to power loss. The
chart at the right describes
the possible settings.