Electrolux Built-In Dishwasher, Service Manual

Page: 38 / 65

38 5995432258
of time the heater is energized is based on ambient
temperature (provided by the ambient thermistor). Below
46°F (8°C), the heater is constantly on. Between 46°F
(8°C) and 80°F (27°C), the heater cycles on and off with
the compressor. Between 80°F (27°C) and 98°F (37°C),
the heater cycles on for 5 minutes and off for 5 minutes,
while the compressor is running. When the compressor is
off, the heater cycles on for 5 minutes and off for 25
minutes. Above 98°F (37°C), the heater cycles on and off,
with the compressor. Check for 120 VAC at CN08 on the
terminal block, between pin #4 and pin #5, when the
heater should be energized or when the refrigerator is in
test mode
0 9 (see Service Diagnostics ). Heater resistance
is approximately 1.9K
Door Water Line Replacement
To remove the existing water line, remove the screws
from the water line retainer at the dispenser, then pull the
retainer off the tubing. From the bottom of the door,
disconnect the water line and pull it down and out.
To install the new water line, soak the new line in hot
water (to make it pliable) and insert it into the door at the
dispenser location. Feed the water line into the door, until
it emerges through the bottom hinge as shown in the
photo below. (The stainless steel panel is shown pulled
away from the door for clarity).
Note: On custom panel models, it may be necessary to
remove the door handle and slide the panel to the right to
feed the water line past the bend.
Main Switch
The main switch is mounted to a bracket at the front of
the machine compartment. The main switch opens both
the line voltage and neutral side to the refrigerator.
When the refrigerator is plugged in, the line voltage and
neutral is supplied at CN01, between pin #1 and pin #2.
Caution: Do NOT connect or disconnect CN1 connector
with power applied. Always turn off power at the main
switch to avoid arcing at connector terminals.
Note: If the refrigerator is dead (no lights or component
operation), check for power to CN1. Ensure the main
switch is operating correctly. Check for loose connectors
at the terminal block.
To check power to the main switch, check for 120 VAC
between the black and red wires on the connector shown
below.