Electrolux Built-In Dishwasher, Service Manual

Page: 5 / 65

5
5995432258
INSTALLATION EXAMPLE 42” MODEL
THE INSTALLATION SPACE
* The finished cutout width must be:
41-1/2” for 42” models
Water and Electrical Locations
The opening must be prepared with the
electrical and water supply located as shown.
The cutout depth must be 24"
The refrigerator will project forward, slightly
beyond adjacent cabinets, depending on
your installation.
Additional Specifications
• A 120 volt, 60Hz, 15 or 20 amp power
supply is required. An individual properly
grounded branch circuit or circuit breaker
is recommended. Install a properly
grounded 3-prong electrical receptacle
recessed into the back wall. Electrical must
be located on rear wall as shown.
Note: GFI (ground fault interrupter) is not
recommended.
• Water line can enter the opening through
the floor or rear wall. The water line installed
should be 1/4" O.D. copper tubing between the
cold water line and water connection location.
The line should be long enough to extend to
the front of the refrigerator. Installation of an
easily accessible shutoff valve in the water line
is required.
*Shipping height
The front height
may be adjusted
from 83-1/2" to 84-1/2"
by adjusting front and
rear leveling legs a
maximum of 1".
DIMENSIONS AND CLEARANCES
Product Clearances
These refrigerators are equipped with a 2
position door stop. The factory set 130° door
swing can be adjusted to 90° if clearance to
adjacent cabinets or walls is restricted
Allow minimum clearances for Freezer
door (Dimension A) and Fresh Food door
(Dimension B) for a full 130° door swing
and to allow for drawer removal.
Four inch (4") minimum clearance is required
when door swing is adjusted to 90°. If the 90°
door stop position is used, drawer access is
maintained, but drawer removal is restricted.
7”
May Change with
our handle
Wood Panel 70 LB food door 30 LB freezer door