Electrolux Built-In Dishwasher, Service Manual

Page: 33 / 65

33
5995432258
motor reed switch. Make sure the shield is in place before
replacing the cover.
The cube motor operates on 120 VAC and has a
resistance of approximately 2K W.
To check the supply voltage to the cube motor, select
CUBED on the ice dispenser control panel, then press the
dispenser pad to close the switch. Check for 120 VAC at
CN07 on the terminal block between pin #6 and pin #7.
The cube reed switch is mounted to the cube motor
housing. A small magnet is attached to the motor lift cam.
The magnetic operation of the reed switch informs the
power control Board (PCB) of the position of the cube
motor lift cam.
To check the cube reed switch:
1. Select CUBED on the ice dispenser control panel, then
press the dispenser pad to close the switch.
2. Check for 5 VDC at CN06 on the terminal block
between pin #3 and pin #7.
3. Select
CRUSHED on the ice dispenser control panel,
then check for 0 VDC at the same pin location with the
dispenser switch in the closed position.