Electrolux Professional 10 GN 1/1, Installation Manual

Page: 43 / 46

43
G.1.2 Digital models
When the oven is installed it is necessary to verify its correct
functionality by carrying out a series of cycles with the following
sequence:
boiler models
1. a cleaning cycle to check the hydraulic system sealing;
2. a steam cooking cycle to check the door gasket sealing;
3. a convection cooking cycle to check the temperature
achievement of 250 ℃ in the cavity.
boilerless models
1. a cleaning cycle to check the hydraulic system sealing;
2. a convection cooking cycle to check the temperature
achievement of 250 ℃ in the cavity.
NOTE!
For detailed information about the above proce-
dures consult the corresponding Service Manual.
G.2 WIZARD (only for touch models)
When the appliance is switched for the first time a procedure
verifies the installation and tests the appliance performances.
This procedure must be completed to guarantee the oven
performances and to allow its use.
The procedure is composed of 3 main steps:
1. General settings for interface configuration;
2. Manual settings for visual confirmation of the correct
installation;
3. Automatic testing of the appliance performance.
General settings
1. Select the required language;
2. Select the “Date“ and “Time“ (set also the time and date
format);
3. Select finally the measurements units;
The display shows a recap of the status of the wizard. The
“General settings“ phase is marked concluded while the others
remain to be performed.
NOTE!
To proceed with the manual settings and the
automatic testing of the appliance performance
consult the Service Manual.
H MACHINE DISPOSAL
WARNING
Refer to “ WARNING and Safety
Information “
H.1 Waste storage
At the end of the product's life-cycle, make sure it is not
dispersed in the environment. The doors must be removed
before scrapping the appliance.
SPECIAL waste materials can be stored temporarily while
awaiting treatment for disposal and/or permanent storage. In
any case, the current environmental protection laws in the
user's country must be observed.
H.2 Recyclability
Our appliances are manufactured using more than 90% metals
(stainless steel, iron, aluminium, galvanised sheet, copper,
etc.) which can be recycled by means of the conventional
recovery structures, in compliance with the current regulations
in the country of use
H.3 Procedure regarding appliance dismantling
macro operations
Before disposing of the machine, make sure to carefully check
its physical condition, and in particular any parts of the
structure that can give or break during scrapping.
The machine's parts must be disposed of in a differentiated
way, according to their different characteristics (e. g. metals,
oils, greases, plastic, rubber, etc.).
Different regulations are in force in the various countries,
therefore comply with the provisions of the laws and compe-
tent bodies in the country where scrapping takes place.
In general, the appliance must be taken to a specialised
collection/ scrapping centre.
Dismantle the appliance, grouping the components according
to their chemical characteristics, remembering that the com-
pressor contains lubricant oil and refrigerant fluid which can be
recycled, and that the refrigerator components are special
waste assimilable with urban waste.
Wizard
Settings manual
Settings automatic
Settings
2019
November
Set date
D/M/Y M/D/Y Y/M/D
Set format
24 H AM/PM
Set time
16:58
Date
Time
1 2
4
3
5
7 8
0
6
9
3 2 1 30 29 28
6 5 4
13 12 11
20 19 18
27 26 25
9 8 7
16 15 14
23
4
10
17
24 22 21
30 29 28
Sun Sat Fri Thu Wed Tue Mon
46
48
47
45
44
Set format
Temperature scale
°C °F
Measurament units