Electrolux Professional 10 GN 1/1, Installation Manual

Page: 42 / 46

42
CAUTION
Make sure the ventilation system is able to
discharge the quantity of exhaust gases
made by the appliance.
2. CONSTRUCTION TYPE “A3“: SOLUTION 2 (dis-
charge under extractor hood with manifold)
D Extension pipe diameter
2D Distance between extension pipe and extractor hood
E Extension pipe (available on the market)
F Adapter ring for extension pipe (available on the market)
G Manifold (not included, to be ordered)
Indications
• The extension pipe and the adapter ring are not included.
They are available on the market.
The pipes must withstand 350
℃ .
• When installing the manifold “G“, always keep the distance
“2D“ between the top of the extension pipe and the lowest
point of the hood filters.
This distance “2D“ is defined on the basis of exhaust pipe
diameter “D“.
• Apply silicone sealant between the contact surfaces.
F.12 Instructions for the exhausting system
Before installation, check that the volume sucked by the fume
exhaust system is greater than that of burnt gases produced by
the appliance according to the reference standard.
CAUTION
Since burnt gases can reach very high
temperatures, check the materials exten-
sion ducts and extractor hood filters are
made from.
CAUTION
Make sure to periodically check the filters.
If clogged with grease and grime, they will
reduce the efficiency of the extraction
system.
G APPLIANCE SET UP
G.1 Introduction
CAUTION
Make sure the appliance is connected to
the water supply, the draining system, the
power supply and, in case of gas model, to
the gas supply and to a exhaust burnt gas
system.
CAUTION
Check the correct working of the door
closing mechanism when the oven is hot.
It may be requested to adjust the position
of the door catch.
G.1.1 Touch models
When you start your new appliance for the first time, you are
prompted for an automatic set-up procedure, called Wizard,
once.
The appliance checks if all the installation steps have been
carried out correctly and performs a series of auto tests. The
Wizard lasts about ca. 30 minutes.
This procedure must be completed to guarantee the oven
performances and to allow its use.
IMPORTANT
This setup is meant to be carried out ONLY by an
authorized technician .
DANGER
Risk of fire! Before running the
wizard remove all packaging and
any items from the cavity.
CAUTION
During operation, pay attention to the hot
areas of the exterior surface.
Do not place objects on the outlets located
at the back top of the appliance.
G
øD
2D
F
E