MAINTENANCE
VistaPro 2000 User's Manual
4-8
Then slide to right and push completely in (Figure 4.8). Push slowly but firmly
to ensure that the module is securely in place and is as far back as possible.
Figure 4.8. Insert new lamp module
Replace lamp retaining bracket
Insert the narrow end of the bracket into the slot on the right side of the lamp
compartment and push firmly to the right. Secure with two screws along the left
edge of the bracket.
Replace both lamp doors
Once the new lamp module is properly installed, replace the inner lamp door.
Insert the tabbed bottom edge first, then swing the top up and tighten the 2
screws. Replace the outer door by aligning the bottom edge and swinging the
door up into place. Pull the top latch of the door down.
Replace side filter
It is a good idea to replace the side filter whenever the lamp is replaced (or more
frequently if the operating environment is very dusty). This filter lies behind the
protruding grill on the side panel of the projector near the front corner (Figure
4.9). Unscrew the 2 screws from the bottom flange of the grill and remove the
grill and filter. Pull out the old filter and replace with the new, taking care that
the filter lies smoothly in place. Replace grill, tabbed end first, and secure with
screws.
WARNING
For safety, only use filters supplied by Electrohome.
Never operate the projector without
the filters installed.
STEP 8
'
STEP 9
'
STEP 10
'