24
184584
ELECTRO FREEZE Soft Serve Models SLX400, SLX400E, SLX500
Figure 8-8
Clean beater shaft
Figure 8-7
Clean shaft seal, washer, plunger,
and nozzle
Figure 8-9
Clean hopper and mix
feed port
Figure 8-10
Clean inside of drain tube
Replace worn brushes. Use
only Electro Freeze original
or authorized replacement
parts.
3. Rinse parts with clear water and
place in sanitizing solution for 5 minutes.
Important:
Do not leave parts in sanitizer for
more than 15 minutes.
4. Place parts on a clean surface and
allow to air dry
5. Using a warm mild dish detergent
thoroughly brush:
a. the hoppers and the mix feed
tubes from the hopper to the cylinders.
(figure 8-9).
b. the inside of the cylinders
making certain to clean the back walls with
4” diameter brush provided.
c. the inside of the drain tube
(figure 8-10). Dip the brush in the dish
detergent solution and force brush into
the drain tube until it stops - repeat until
clean.
6. Repeat step 5 using a brush to
rinse with water and then brush with sanitiz-
ing solution.
7. Remove the drip tray and insert.
Wash in a warm dish detergent solution,
rinse with clear water and place in santizing
solution for 5 minutes.
8. Wash the outside of the freezer and
inside of the cabinet with a warm dish
detergent solution. Rinse with water
8.3
Cleaning Instructions
(continued)
