Electra CON 12, Service Manual

Page: 124 / 137

13
Befor performing any maintenance procedure,
make sure to disconnect the air conditioner from
the power.
To remove the air filters lift up the panel. Push
the air filters up slightly to unlock them. Pull out the
filters clean the filter by washing in warm soapy
water and dry thorougly Align and fit the filters in
place. Close the panel by pushing it in the center
to lock it in place.
PURIFICATION FILTER REPLACEMENT
The air purifying filter should be removed from the
unit and replaced once a year, as shown in figures
1,2 and 3.
Pulling out the filter
Replacing and securing the filter in its frame
Sliding the filter back in its place
Note: The above procedure is used for replacing
the active carbon filter (when supplied).
DO NOT OPERATE THE UNIT WITHOUT FILTERS !
Wipe the unit with a soft dry cloth or clean it
using a vacuum cleaner.
Do not use hot water or volatile materials which
could damage the surface of the air conditioner.
Make sure there are no obstacles blocking the
flow of inlet or outlet air, in both indoor and outdoor
units.
Make sure the power is properly connected.
Indoor unit and remote control must be at least 1
meter away from a TV. radio or any oter home
electronic appliance.
Protect the inner unit from direct sun or lighting.
Remove the batteries from the remote control as
shown.
Use two 1.5 volt size AAA batteries
CLEANING THE AIR FILTER
CLEANING THE AIR CONDITIONER
AT THE BEGINNING OF THE SEASON
PROTECT THE ELECTRONIC SYSTEM
REMOTE CONTROL BATTERY CHANGE
·
·
·
·
·
·
·
·
·
CARE AND MAINTENANCE
3
2
1