ELBO CONTROLLI SETHY SIX, Installation, Operation And Maintenance Manual, Page: 8 / 96

5 WARNINGS ELBO CONTROLLI srl
SETHY SIX
5 WARNINGS
5.1 Introduction
This operation and maintenance manual, concerning the SETHY SIX Presetter should be considered as an
integral part of the apparatus and should therefore be kept with care for future reference.
All the procedures and information contained in this manual cannot be a substitute for the end user’s
adequate tool presetting knowledge but they provide the necessary information for the correct and proper
use of the SETHY SIX presetter.
Unauthorised equipment handling, non-compliance of instructions, improper or incorrect use may lead to
unforeseen results for which ELBO CONTROLLI S.r.l. declines all civil or criminal liability.
ELBO CONTROLLI S.r.l. reserves the right to modify at any time the tool presetter and the operator’s
manual without prior notice, on account of the continuous technical updating of the product in pursuit of
the Company strategy aimed at perfecting presetting technology of tool measurement and presetting and
to achieve ultimate customer satisfaction.
All suggestions for improvement to the apparatus or manual are welcome either by fax or letter to our
head office.
5.2 Purpose
The aim of the manual is to allow the SETHY SIX Presetter operator to become acquainted with the
machine’s operating directions, routine and non-routine maintenance and the proper operating procedures
and to show all the required necessary actions from the presetter introduction until its disposal.
ELBO CONTROLLI S.r.l. only approves the allowed uses and the reported configuration; any other use
or configuration is not recommended, as it may compromise the tool’s proper functioning and/or its
safety. This manual does not replace the knowledge and the technical expertise of the personnel involved
in the use of the Presetter machine and is to be considered as a guide before and during use.
This manual must be read following the chapters in their logical order, because the repeated
information is explained in full only the first time it appears; afterwards it is just mentioned
because it constitutes knowledge already acquired.
5.3 Font characters and heading layout
This manual is subdivided into chapters, which contain homogeneous information; each chapter is
identified by a title in the following typographical character:
X. FIRST CHAPTER
Each chapter is identified by a title in the following text format:
X.X FIRST PARAGRAPH
The operation or maintenance procedures are identified by:
Procedure
Then the procedure will be identified with:
•
step 1
•
step 2
Page 8 of 96