6. DESCRIPTION OF COMMAND ELBO CONTROLLI srl
Preset E236+
20
6.4 BASIC FUNCTIONS
6.4.1 TURNING ON
To turn on the instrument by inserting the 24Vcc power supply pin into
the socket found on the rear panel; then insert the feeder plug into an
electric socket (115-230Vac).
If the machine is already on, just press any point on the touch screen to
exit the standby mode.
The LCD display, while the software is loading, will now show the text
“LOADING” and the software version, important to report any
anomalies or to determine a possible upgrade.
After a few seconds, E236+ will be ready to operate and signals the need
to pass over the reference points for both axes by showing the
measurements blinking (red axis X – blue axis Z).
Turning on always activates the autocollimation mode
As shown in the picture, the functions Machine Origins and Toolsets are
disabled until the reference point for both axes are reached.
Move the axes of the instrument in rapid mode, so that the measurements
stop blinking and display in a correct way.
Once reached the reference points, the functions Machine Origins and
Tool Set are enabled.
þ
In case of mechanical maintenance or technical assistance of the
detection system, the reference zero-point moves. Therefore, it will be necessary to check and reset the
absolute origin with a control gauge.
Disabled functions
Functions enabled
