5. PREPARATION AND INSTALLATION ELBO CONTROLLI srl
Preset E236+
16
To check and if necessary, to restore the correct settings following the instructions that are printed from
time to time: To modify the settings press and keep pressed the push-button
until the start of the paper
(press length/time: >1 sec.).
It will now print a single setting and it will be possible to modify it with a brief press of the button
,
or confirm it with a longer press.
In case of an error in the setting it is necessary to repeat the procedure from the beginning.
At the end the printer will show the current setting, as it should be:
The printer will always keep this setting, for this reason it won’t be
necessary to modify it more.
For everything non-specific in the present document, it is necessary to refer
to the respective instruction manual, the one for the printer is downloadable
on-line at
www.custom.it
.
In the case in which the printer doesn’t produce any label, or that the printed
letters are incomprehensible, check the correctness of the settings as in the
illustration above.
Setting to edit:
Enable
Setting to edit:
RTS/CTS
To darken the print set +1 o
+2.
Setting to verify:
CR disabled
Setting to edit:
19200 bps
1 9 2
