ALMAG-01
Operating manual Page 10
Note: In order to activate the device running mode it is necessary to unplug the device
from mains and then to plug it again in ten minutes break.
The blinking of green color LED in the center of each of four coils confirms
availability of ALMAG serviceability. There is another means to check-up ALMAG
device operating state, the indicator of a magnetic field is to be put on coils – inductors in
turn. The presence of a pulse magnetic field will be followed with a blinking of a green
bulb in the centre of the indicator or by vibration of the indicator of a magnetic field
(depending on kind of the inductor).
Both sides of the coils-inductors are serviceable, therefore treatment can be carried out
by the side which is most convenient.
Due to high penetrating ability of a magnetic field of the device treatment can be
carried out also through clothes, a dry or damp gauze bandage, 1sm thick plaster bandage.
Take notice. Because of magnetic induction value of ± 6 mTl the glowing of green
light o in the centre of inductor on the different surfaces of coils-inductors may be
different on the check of the device state of operability. This can reveal itself if we
remove magnetic field inductor from the surface of coil-inductors.
4.3 Marking
The markings on the Device are as follows:
The mark defines the device as complying to Class II as regards electrical
safety according to IEC 601-1-88;
“Caution, refer to the Operating Manual”;
“B type device”
The mark defines the device as complying to B type in regard to electric shock
safety according to IEC 601-1-88.
5 SAFETY MEASURES
5.1 Please study the present Operating Manual carefully before you start to use the
Device.
5.2 Perform external inspection of the Device prior to its application. There should be
no the signs of damage both on the device body and coils-inductors or cable.
!
