21
090060699 -
USER MANUAL -
VILLEGGIO
In case of user access (via keypad or M4 proximity key) keypad ’operating area’ will be automatically set
according to user’s areas authorized.
Note:
in case of user inactivity, the keypad shows presenting area and the welcome message.
Note:
EN50131 standard provides for no indications on system operating status while the system is armed.
If EN50131 standard
Visualization Protection
option is active, the four system status LEDs (arm/disarm,
anomaly, alarm memory, tamper memory) will be OFF while the system is armed and will still be OFF when
the inactivity time expires.
4.20.2 Display of zones status, anomalies and memories
To display zones status, anomalies and alarm memories use
Status Display
menu.
To enter
Status Display
menu use UP / DOWN arrow keys when interface is in idle status.
Information provided refers only to current operating area.
Note:
if EN50131 standard
Visualization Protection
option is active, an authenticated access (six-fi-
gure user code followed by
or
key) is required to enter the status display menu.
4.20.3 Multiple areas arming
If one of the affected areas cannot be armed upon system arming, the command will not be authorized.
4.21 Maximum security function control
This appendix will explain maximum security control using relevant icons.
Maximum security mode can be activated for one or more sectors; when a sector is armed in maximum
security mode it can be disarmed in the following ways:
- by a user with maximum security property
- using the weekly programmer
BACKLIGHT OFF
RED BACKLIGHT
AREA SELECTION
(GREEN BACKLIGHT)
(GREEN BACKLIGHT)
BACKLIGHT OFF