EKOM DK50-10 Series, User Manual

Page: 22 / 120

INSTALLATION
NP-DK50-10-A-4_10-2019-MD 22 10/2019
12.2. Connecting a compressor installed in a cabinet

Route the mains plug through the opening in the rear wall of the cabinet for cabinet-mounted
compressors.

Connect the cabinet DK50-10S/M 8-10bar electrically to the compressor by inserting the provided
power cord with connector (1) into an outlet. (Fig. 8)

Disconnect the cabinet electrically from the compressor by pulling the connector (1) from the
outlet while the latch is released.
Fig. 8: Connect the cabinet DK50-10S/M 8-10bar to the compressor
13. COMMISSIONING

Check if all fixing elements used during transport have been removed.

Check correct connection of compressed air (see Chapter 11).

Check correct connection to the mains (see Chapter 12).

Check position of the circuit breaker switch, i
t must be in position „I“. If it is in position „0“, turn the
switch (4) to position „I“. (Fig. 9).

Check, if DK50-10S/M compressor cabinet (only 8 - 10 bar) is connected with the compressor by
a cable with a connector. (Fig. 8).

On DK50-10S/M (8 - 10bar) compressor, switch the switch (5) on the front side of the cabinet to
position „I“, the green light indicates the device status in operation. (Fig. 9).

Check correct function of the safety valve (see Chapter 17.6).
The compressor is not equipped with a backup power supply.
1
2