EKOM ASPINA DO M, User Manual

Page: 29 / 196

TROUBLESHOOTING
12/2021 29 NP-DO M-39_12-2021
TROUBLESHOOTING
Risk of electric shock.
Before interfering with the equipment, first disconnect it from the mains (remove
the power socket).
Troubleshooting may only be performed by a qualified service technician.
Danger of biological hazard and environmental pollution.
Follow the rules of personal hygiene for manipulation with contaminated
material. Separate, label, pack and ensure decontamination of contaminated
parts according to local regulations.
In case of repair of parts of device which might be contaminated please follow bellow mentioned
instruction:

Disconnect the appliance from mains

To follow the rules of personal hygiene for works with contaminated material

Clean device according, section 14.

To separate, label, packing and providing for decontamination of contaminated parts by course
of national regulations

To perform the repair of damaged parts
Failure Problem and possible reasons Way of removal
Suction equipment
does not work
Mains voltage absent Check mains voltage in the socket, activate a
protective element in the electric distribution
(fuse, circuit breaker)
Interrupted supply of el. energy
Power-supply switch off Check the power-
supply switch position ( „I“),
switch on the power-supply switch (network
indicator goes on)
Interrupted power cord
Replace the defective part
Loose clamp of terminal board
Tighten the clamps
Interrupted motor wiring, defective
thermal protection
Replace suction pump
Defective mains fuse of the
equipment
Check the state of equipment mains fuse,
replace defective fuse (fuses 2 x T 6.3 A are
situated in the upper, narrowed part of the
suction equipment)
Full separation vessel Empty the separation vessel content
High current consumption Defective starting capacitor, replace the
capacitor
Suction equipment is/was awash by
liquid
Suction equipment pass on repair to service
–
keep all rools and norms for work with