Operating instructions ekamove Rev 3 Date: June 2017 33
corresponds to approx. 5°, which means that 6 minutes equals
about 30°.
Adjustment is done by pressing and holding the Angle key while
simultaneously activating the Plus or Minus key.
You can now make the setting for the desired positioning time for
this partial po
sitioning stage. Press and hold the “Time” key; the
positioning time is displayed in the right-hand side of the display.
You can now alter this by keeping the “Time” key depressed and
activating the “Plus”(+) or “Minus”(-) key.
The value set will be adopted automatically when you release the
“Time” key.
Once you have set the values for the left partial positioning stage,
by pressing the “Prog” key you will go to the next partial positioning
stage (
in this case “N” for the supine position). You should proceed
in the same way as for setting the left side, except that you do not
select any angle here.
All you need to do now is follow the same steps for the right partial
positioning stage and you have now programmed an individual
positioning.
It is also possible to deselect a partial positioning stage. The
“deselection” of a partial positioning stage can be done by
selecting the positioning stage and pressing the “Plus” or “Minus”
key. The partial positioning stage you have deselected will be
represented by an X.
You can leave the programming mode by pressing the “STOP”
key.
Now you can start the programme you have entered by pressing
the “Start” key and the positioning stage will now be executed.
