Operating instructions ekamove Rev 3 Date: June 2017 22
9 Putting the apparatus into operation
9.1 Switching on
The ekamove® system is switched on by activating the main
switch (switch set to 1).
The word ekamove® appears in the display and the deflation of the
air chamber system begins (lasts about 5 minutes). The word
“EMPTY” appears in the display. If the air chamber system has
already been completely deflated, you can end this process by
pressing the “STOP” key twice. There now follows an automatic
calibration of the sensors (whereby the sensors are adjusted to the
ambient conditions). The display then changes to the last
positioning programme or, in case of initial installation, to the
programme set in the factory.
9.2 Setting the date/time
The date and time have already been set in the factory. However, if
it is necessary to change the date/time, please proceed as follows:
By pressing the “Prog” and “Time” keys once at the same time you
go into the setting mode for date and time. In the display on the left
(programme display window) a “D” (D=day) will be shown and in
the right-hand side of the display, the day set. This value can now
be changed
by pressing and holding the “Prog” key and operating
the “Plus” or “Minus” key. When the correct day is set, the “Prog”
key is released.
The next value can now be
selected by pressing the “Plus” or
“Minus” key. An “M” (M-month) appears in the display on the left
