eka KF 630 D UD, Use And Instruction Manual

Page: 15 / 19

_ Electric Ovens _ rev. 2 _______________________________________ KF 630 D UD – KF 733 D UD – KF 937 D UD
KF 966 D AL UD – KF 966 D UD _
________________________________________________________________________________________ page. 15 _
2 2 2 22 2 2 2. Possible faults . Possible faults . Possible faults . Possible faults
Type of fault Type of fault Type of fault Type of fault Cause Cause Cause Cause Corrective action Corrective action Corrective action Corrective action
- Incorrect electric connections to the mains - Check the mains connection
-
No mains voltage
-
Restore mains voltage
-
Thermal break safety device tripped
-
Reset the thermal break safety
device
Control panel
completely off (the
oven does not work)
-
Electronic card protection fuse (control panel)
burnt
-
Change the fuse
- Door open or ajar - Close the door
Cooking cycle set and
push button
pressed: the oven
does not work
-
Damaged door switch device
-
Contact a qualified technician to
repair the sensor
- Incorrect connection to water mains
- Connection of non-conforming pump
- Check the connection to water
mains (electrovalve) or the
connection of pump
- Cut-off cock closed (electrovalve)
-
Tank without water (pump)
- Check the cut-off cock
-
Check water level into the tank
-
Blocked water inlet filter
-
Clean the filter
Humidity production
in cooking chamber
on: No water flows
from the pipes
(on the fans)
-
Electrovalve or pump water entrance damaged
-
Contact a qualified technician to
repair the solenoid
- Seal not fitted correctly - Check the seal fitting
-
Damaged seal
-
Contact a qualified technician to
repair the seal
Door closed: water /
vapour comes out of
the seal
-
Handle mechanism loosened (lateral opening
door)
-
Contact a qualified technician to
repair the prong
- One of the motors is blocked or turns slowly (If
the oven has two motors)
- Contact a qualified technician to
repair the motor
-
The motors do not go into reverse
-
Contact a qualified technician to
repair the motor
The oven does not
cook evenly
-
Heating element not powered or is damaged
-
Contact a qualified technician to
repair the element
- Damaged lamp - Change the lamp
Lighting lamp in the
cooking chamber does
not work
-
Light bulb “unscrewed”
-
Make sure the light bulb is fully
screwed-in.
- Breaking in the connection between the cooking
chamber probe (electronic card) and the control
panel
- Check the connection to the
control panel “ER1”
“ER1” “ER1”
“ER1” appears on the
display
-
Damaged cooking chamber probe
-
Contact a qualified technician to
repair the probe