_ TECNOEKA Srl __________________________________________________________ use and instruction manual _
_ page. 12 ________________________________________________________________________________________
13. Delayed start to the cook
13. Delayed start to the cook
13. Delayed start to the cook
13. Delayed start to the cooking cycle
ing cycle
ing cycle
ing cycle
To delay the start for the cooking cycle, proceed as follows:
•
Set the required parameters for each phase in the cooking cycle, following the
instructions in the paragraph “OPERATING METHOD” (paragraph 10).
•
Press the
key until all the signal leds go out on the control panel. The message
“0.00” appears on the display.
•
Press the
/
keys and set the required “DELAY TIME” on the display (maximum 9
hours and 59 minutes).
•
Press the
key to activate the delayed start.
The led on the
key starts flashing to show that the COUNTDOWN has started shown on
the display. The DELAY TIME can be changed at any moment during the COUNTDOWN by
pressing the
/
keys.
When the DELAY TIME is up, the cooking cycle will start automatically.
To zero the DELAY TIME, just press the
key; the display will show the operating
parameters than can be changed. Press the
again to continue the cooking cycle;
otherwise a delayed start for the cooking cycle can be reset by proceeding as above.
N.B.: in case of BLACKOUT or power failure during the COUNTDOWN, the programmed
delay for the cooking cycle is cancelled and all the relative set parameters are zeroed.
A delayed start to the cooking cycle is only possible in MANUAL MODE. It cannot be included
in a programmed cooking cycle.
1
1
1
14
4
4
4. “Programmed” mode
. “Programmed” mode
. “Programmed” mode
. “Programmed” mode
Up to 99 cooking programs (cycles) can be saved. Each program can include 1 or more cooking
steps (up to 4).
1
1
1
15
5
5
5. Saving cooking programs
. Saving cooking programs
. Saving cooking programs
. Saving cooking programs
Follow the steps below to save a cooking program:
-
press the button
(led on) “P01" appears on the display.
-
Press buttons
and select the required program number (up to P99).
-
Set the relevant cooking cycle parameters following the same procedure used for
“manual” mode.
-
Press and hold down the
button for at least 5 seconds: the program is successfully
saved with the saved program number blinks on the display.
To cancel a saved program, simply replace it with a new program (with the same number)
where new parameters are set for the new cooking cycle. The new program must be saved
by pressing the
button.
