28
Chapter 3 Touch Panel Settings
●
Checking operation
1. Launch the Windows Paint application.
2. Hold the stylus vertically to the touch panel, and draw a line from left to right.
3. Make sure the line is visible. If the line is not visible, check whether the power is turned on.
Attention
• When using the stylus, hold a part near the pen tip tight. If you hold a part a certain distance from the pen tip
or hold the stylus too lightly, sensitivity may reduce.
• Exercise care that you do not touch the cap while using the stylus. The touch panel operations will be
disabled if you touch the cap while using the stylus.
•
Handle the pen tip with care since it is fragile and may be damaged if the stylus is dropped.
●
Replacing the rubber tip
When the rubber tip is worn away or broken, it must be replaced.
Attention
•
Do not use the stylus if the rubber tip is broken or removed. Doing so may scratch the monitor surface.
Replacement procedure
1. Twist the rubber tip and slowly pull it out.
2. Insert a new rubber tip all the way.
Rubber tip
Rubber tip
Attention
•
Do not forcibly push in the rubber tip. Doing so may break the rubber.
