8
4. Push the locking lever down
Adjustment of the shoe (cutting angle) (Fig. 5)
1. Release the lock screw 1
2. Adjust the shoe to the desired angle between 0
and 45°.
3. Tighten the lock screw 1.
Changing the saw blade (Fig. 6)
Important! Pull out the plug before making any
changes to the circular saw!
1. Open the hinged guard hood 1 and hold.
2. Use the face spanner 2 to stop the saw blade
from moving.
3. Undo the screw
4. Remove the flange 4 and the saw blade by
dropping down and out.
5. Clean the flange and insert a new blade. Note the
direction of rotation (see arrow on the guard
hood).
6. Tighten the screw and check for concentricity.
Switching on
Before pressing the On/Off switch, check that the
saw blade is properly fitted, that the moving parts run
smoothly and that the clamping screws are tight.
Fitting and removing the splitter (Fig. 7)
1. Undo the recessed head screws 1 and remove.
2. Pull the splitter 2 down and out.
3. Fit in reverse order.
Switching on and off (Fig. 8)
To switch on:
Press the interlock button 3 and
the switch 4 simultaneously.
To switch off:
Release the interlock button and
the switch.
6. Maintenance
앬
Keep the cooling vents on the motor housing clean
and unobstructed at all times. Blow out any dust
and dirt at regular intervals.
앬
Have a specialist workshop check the carbon
brushes in the event of excessive sparking.
앬
Worn carbon brushes are to be replaced only by a
specialist workshop or by our Customer Service
Centre.
앬
Keep the machine clean at all times.
앬
Never use any caustic agents to clean the plastic
parts.
앬
If ever you discover any damage, consult the
exploded drawing and parts list to determine
exactly which replacement parts you need to order
from our Customer Service Centre.
7. Ordering replacement parts
Please quote the following data when ordering
replacement parts:
앬
Type of machine
앬
Article number of the machine
앬
Identification number of the machine
앬
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
GB
Anleitung HS 1300_SPK1 30.03.2006 15:33 Uhr Seite 8
