Eickemeyer 195070, User Manual

Page: 25 / 28

25
USER MANUAL
ORTHOVET PLUS BATTERY DRILL SYSTEM
T +49 7461 96 580 0 | F + 49 7461 96 580 90 | export@eickemeyer.com | www.eickemeyer.com
6. SYSTEM SPECIFICATIONS
Environmental Conditions
Operation Storage
Temperatur
Humidity 30 % 90 % 30 % 90 %
Atmospheric Pressure 500 hPa 1,060 hPa 500 hPa 1,060 hPa
Technical Data OrthoVet Plus (item no. 195070)
Continuously adjustable speed 0 – 1,000 rpm
Weight with battery 970 g
Operating voltage 7.2 VDC
Battery capacity 1.2 Ah
Battery type NiMH
Empty battery charging time max. 180 min
Degree of protection against electrical shock B
Degree of protection against the penetration of water IPX4
Noise level in operating position (with chuck item no. 195079): ca. 65 dB(A)
Technical data is subject to tolerances. Specifi cations are approximate and may vary from one device to another or as a result of power supply fl uctuations.
Duty Cycles / Intermittent Operation
Duty Cycles Intermittent operation Cycles
Drilling, tapping and reaming 60 seconds 9
Burring 60 seconds 3
KIRSCHNER-Wire setting 30 seconds 6
Sawing 30 seconds 5
Generally, electrical systems can heat up if in constant use. For this reason, the handpiece and the attachment should be
allowed to cool for at least 60 seconds. After a certain amount of cycles (defi ned in the above table under “Cycles”), the
handpiece and attachment should be allowed to cool for 30 minutes. If this is observed, the system will be prevented from
overheating and possibly harming the patient or user. The user is responsible for the application and for turning off the
system as prescribed. If longer periods of constant use are required, an additional handpiece and / or attachment should be
used.
Depending on the cutting tool used and on the load applied, the heat generation of the handpiece, attachment and / or cutting
tool can vary. Always control the temperature of the system to prevent overheating and possibly harming the patient or user.