15. Lift and pull the bedliner as shown to gain access to the wiring located in the side panel of the vehicle. Disconnect the stop light
wiring plug located behind the bedliner, by pushing down on the tag on the connector using you finger or a flat blade screwdriver.
See Dia #15
.
NOTE: This connector is located above the wheel arch towards the rear of the vehicle.
Diagram #15
16. The hardware kit contains both the wiring adapter loom and the wiring harness. As only the wiring harness is required for this
installation, do not use the wiring adapter loom.
See Dia #16.
Diagram #16
TC0123b
page 10 of 28
3PC TONNEAU COVER WITH SPORTS BAR & REMOTE LOCKING
21/05/08
17. Insert the wiring harness supplied in hardware kit between the two stop light wiring plugs as shown.
See Dia #17.
Diagram #17
BEDLINER
STOP LIGHT
WIRING PLUG
BEDLINER
TAILGATE
SEAL
1
2
DISCONNECT
WIRING ADAPTER
LOOM
WIRING
HARNESS
DISCARD
KEEP
STOP LIGHT
WIRING PLUG
STOP LIGHT
WIRING PLUG
WIRING HARNESS
SUPPLIED IN
HARDWARE KIT
CONNECT
CONNECT
