INDOOR SPEED MODULE
108
The technical materials and information contained in this document are strictly confidential and the exclusive property of Advanced Microwave Engineering s.r.l.
These materials and information are intended solely for the purpose designated and may not be used otherwise.
It is not permitted to disclose or reproduce them in whole or in part without express written permission.
To configure the speed sensor, follow these steps:
1.
SENSOR POSITION
: Check that the position of the sensor is correct by means of the values on the right side of
the display. The values must be between the following ranges:
Ax
negative value between -1510 and -1390
Ay
value tending to zero between -60 +60
Az
positive value between 1510 and 1390
If the values are not between the ranges defined, review the installation of the sensor and check that the
inclination angle of the sensor is at 45° compared to the ground.
2.
SENSORS CONFIGURATION
: Set the direction of the vehicle so that, if the vehicle is driven forward, front
sensors increase their detection range and rear sensors are reduced at minimum, and vice versa in reverse gear.
The lateral sensors do not change the power when the direction of motion is changed.
Select the sensor to be configured and set if it is:
Forward
: front sensors (green)
Rear
: rear sensors (red)
Lateral
: lateral sensors (yellow, if any)
3.
DIRECTION OF THE VEHICLE:
check that:
o
if the vehicle is driven forward, the value indicated in the direction box is > or = to 0 and that the circle is
green.
o
if the vehicle is driven backward, the value indicated in the direction box is < or = to 0 and that the circle
is red.
o
If signals are inverted, press the REVERSE DIRECTION key.
If the first SPEED box shows -0.1, the sensor has operation problems or it is not active.
