INDOOR SPEED MODULE
105
The technical materials and information contained in this document are strictly confidential and the exclusive property of Advanced Microwave Engineering s.r.l.
These materials and information are intended solely for the purpose designated and may not be used otherwise.
It is not permitted to disclose or reproduce them in whole or in part without express written permission.
21
INDOOR SPEED MODULE
P LX SENAD
21.1
INSTALLATION
The indoor speed module includes the speed sensor that must be fitted correctly on the vehicle.
The speed sensor must be fitted at a 45° angle from the ground, between 30 and 50 cm above the ground.
The sense of assembly must take into account the position of the cable gland, as shown in the drawing.
In order to fit the indoor speed sensor, a metal joint that must be used to fasten the sensor to the vehicle is supplied.
Create an anchoring clamp (not supplied) on the vehicle, onto which the joint can be fixed with 3 in-line holes, Ø4mm,
17.5 mm apart.
Fix one part of the joint to the sensor, and the other to the anchoring clamp. Connect both parts of the joint with the nuts
supplied.
The indoor speed sensor is supplied with a 5-m UTP cable which must end with an RJ45 connector (see section 8.3.1) and
must be connected either directly to a sensor port of the CPU or to a splitter.
