Operation of EFAS – Driver and Co-Driver
48
EFAS
Clearing a Paper Jam
1. Remove the printing module. For instructions, see the
section "Inserting a Reel of Paper" on page 45.
2. Remove any crumpled or tattered paper.
3. Insert the paper evenly and smoothly into the paper
feed.
4. Insert the printing module into the digital tachograph.
3.17
Completing Activities (Handwritten Form)
If the digital tachograph is defective, the driver and/or co-
driver are required by regulation to complete the activities in
hand-written form. To do so, use the back of the paper
which is inside the printer module. Refer to the section
"Inserting a Reel of Paper" on page 45.
Note
Please observe the applicable national regulations!
3.18
Monitoring Speed
Besides statutory monitoring of the highest permissible
vehicle speed, EFAS also enables monitoring of an individ-
ually programmable speed limit. To activate the speed limit,
proceed as follows.
1. Use cursor keys
or
to activate the speed display.
2. Press
OK
when the programmed speed is reached.
EFAS displays the programmed speed for approxi-
mately 2 seconds. Then the previously displayed
driver information is displayed.
The activation of speed monitoring is indicated by the
pictograms “>>“ in the centre of the second line.
When the individually programmed speed limit is
exceeded, the following display is shown for approx.
4 seconds. A long beep is heard and the red LED
flashes.
