EFKA AB60D1472
64
Technician Level
Code no. 190 with control operation
Parameter
Designation
Unit
max
min
Preset
Ind.
179
Sr5 Control program number with index and identification
number. Upon pressing the appropriate key the data
will be displayed in succession.
Control display:
Press
the
E
key
Display e. g.
467
Press
the
>>
key
Display e. g.
h
Press
the
>>
key
Display e. g.
00
Press
the
>>
key
Display e. g.
04
Press
the
>>
key
Display e. g.
20
Press 2x the
P
key
Display shows no reading
180
ird Number of reversing increments
incr.
100
0
60 *)
A
181
drd Switch-on delay of reverse motor rotation
ms
990
0
10 *)
A
182
Reverse motor rotation On/Off
ON/OFF
OFF *)
A
183
Switching off the flip-flop functions at the seam end
1
0
0
A
0 = Flip-flop 1 not switched off at the seam end
1 = Flip-flop 1 switched off at the seam end
184
c6 Number of run-out stitches when unlocking the stitches
254
0
20 *)
A
chain (effective only if parameter 190 = 3 and
290 = 7)
185
chP Stitch counting high lift for walking foot
stitches
254
0
0
A
190
Function “unlocking the chain” in modes 4, 5, 6 and 7
4
0
2 *)
A
(parameter
290)
0 =
Unlocking the chain Off
1 = Unlocking the chain manually (with pedal in
pos. –2 without cutting at the seam end)
2 =
Unlocking the chain automatically
- with light barrier or
- pedal in pos. –2 (parameter 019) without
cutting at the seam end
3 =
Unlocking the chain automatically
- with light barrier or
- pedal in pos. –2 (parameter 019) with cutting
and run-out stitches (parameter 184) at the
seam end, then unlocking the chain (only if
parameter 290 = 7)
191
Seam end in the overlock mode by end count c2 or c4
1
0
0
A
0 = Seam end after count c4 – tape cutter
1 = Seam end after count c2 – chain suction
192
Speed of the light barrier compensating stitches ON/OFF
OFF *)
A
OFF = Speed n5 after light barrier sensing
ON = Speed pedal controlled
193
Enable chain suction signal
ON/OFF
OFF
A
OFF = Chain suction signal after the light
barrier compensating stitches
ON = Chain suction signal from light barrier
uncovered
onwards
195
Stitches for light barrier monitoring
stitches
2550 **)
0
0
A
(light barrier monitoring is off, when set to “0”).
196
Function “chainstitch thread trimmer”
1
0
0 *)
A
(only if parameter 290 = 5)
0 = Chainstitch thread trimmer in general
1 = Chainstitch thread trimmer Pegasus
197
dr° Stop for thread trimming depending on angle
degrees
510
0
360 *)
A
*)
Depending on the selected mode. See table at the beginning of the List of Parameters!
**) When programming the 3-digit or 4-digit control parameter values, the 2-digit or 3-digit value displayed must be
multiplied by 10.
