Subnet Mask
Set the subnet mask for printing with TCP/IP on your network.
Note:
Before proceeding, confirm the subnet mask setting with your network administrator.
Gateway Address
Set the gateway address for printing with TCP/IP on your network.
Login Timeout
Specify when the PS-17 times out after you log on.
When you finish making changes, save the changes. The PS-17 requires a reboot in order for any
Setup
changes to
take effect.
LAN Security (802.1x)
The PS-17 can seek authentication from an 802.1x authentication server (such as a RADIUS server), often through
an intermediate access point (an authenticator).
The PS-17 seeks this authentication at startup, or when the Ethernet cable is disconnected and reconnected. If the
PS-17 is successfully authenticated, it is allowed access to the network.
Enable 802.1x Authentication
Select to allow the PS-17 to seek authentication from an 802.1x authentication server.
Select EAP Type
Choose the type of EAP (Extensible Authentication Protocol) available. If you want to choose the type of EAP as
EAP-TLS
, access
Configure
>
Network
>
802.1x Authentication
to choose
EAP-TLS
.
Note:
Username
The PS-17 uses this information to request authentication from an 802.1x authentication server.
Note:
Use ASCII code characters (63 characters maximum). It is possible to enter more, but the supported length is 63
characters maximum. Although you can enter characters other than ASCII code characters, only ASCII code
characters are guaranteed for authentication.
Configuration and Setup
Accessing PS-17 options through the printer control panel
28
