Efco SmartSL, User Manual

Page: 57 / 70

SmartSL User Manual
50
6.4.23 Info Report Configuration Submenu
Feature Options Description
Post Report
Disabled
Post Report Support Enabled/Disabled
Enabled
Delay Time 5 Post Report Wait Time: 0~10 Seconds
Info Error Message
Disabled
Info Error Message Support Enabled/Disabled
Enabled
Summary Screen
Disabled
Summary Screen Support Enabled/Disabled
Enabled
Delay Time 5 Summary Screen Wait Time: 0~10 Seconds
6.4.24 USB Submenu
Feature Options Description
USB Module Version No option BIOS USB module version
USB Controllers No option Number of USB controllers found on the system
USB Devices No option Number of USB devices found on the system
Legacy USB Support
Enabled
Enable legacy USB support. Auto option
disables legacy
Disabled
support if no USB devices are connected.
Disable option will
Auto
keep USB devices available only for EFI
applications and BIOS setup.
xHCI Hand-off
Enabled
This is a workaround for O/S’ without xHCI
hand-off support.
Disabled
The xHCI ownership change should be claimed
by xHCI O/S driver.
USB Mass Storage Driver Disabled
Enable or disable USB mass storage driver
support.
Support Enabled
Port 60/64 Emulation
Disabled
Enables I/O port 60h/64h emulation support.
This should be enabled for complete USB
keyboard legacy support for non-USB aware
O/S’.
Enabled
USB Transfer Timeout
1 sec
The timeout value for control, bulk, and interrupt
transfers.
5 sec
10 sec
20 sec
Device Reset Timeout
10 sec
USB mass storage device Start Unit command
timeout.
20 sec
30 sec
40 sec
Device Power-up Delay Auto
Define maximum time a USB device might need
before it accurately reports itself to the host
controller. Auto selects a default value, which is
100ms for a root port or derived from the hub
descriptor for a hub port.
Selection Manual