BO08A01KNXFI01010002.DOC
Din Rail 8 Output Module– Product Handbook
4/51
Eelectron SpA, Via Magenta 77/22, I-20017 Rho (MI), Italia
+39 02.9316681 +39 02.93507688
[email protected] www.eelectron.com
BO08A01KNXFI01010002.DOC
C.F. e P.IVA 11666760159
Capitale sociale: 800.000,00€ interamente versato
Tribunale di Milano 359157-8760-07
CCIAA Milano 148549
1. General Introduction
This manual is intended to be used by installers and describes functions and parameters of the
device BO08A01KNX – Din Rail 8 Output Module and how is possible to change settings and
configurations using ETS software tool.
2. Product and functional overview
The BO08A01KNX module is designed to be installed on a DIN rail and to be used in Home and
Building installations (i.e. offices, hospitals, hotels, private houses, etc...).
Device 8 outputs on board can be configured in different ways:
Each output can be configured independently for load control (R1 to R8)
Each output can be configured independently for ON / OFF or continuous switching
(PWM) for Electric valves (solenoid actuators) (EV1 to Ev8)
Outputs can be configured in pairs for the management of roller shutters and blinds; up
to 4 channels (Channels A to D)
Outputs can be configured in pairs for management of Motor Reductor or for solenoid
valves with 3-point control or for
ventilating grilles
; up to 4 channels (Channels A to D)
Fan Coil Actuator for 2/4 pipes systems for Heating / Cooling with 3 speed motors) (
relays from 1 to 5)
Different configurations can exist simultaneously on the same device as long as they do
not use the same outputs (relays), for example you can set the following configuration:
Relay 1 to 5
Fan Coil Actuator
Out
6
Generic load managment
Out 7 ÷ Out 8
Shutter management (Channel “D”)
Scheme of all possible configurations for each output:
Relay
Generic
Load
Fan Coil Act.
Shutter /
Blinds
Electric
Valves
Motor
Reduction
Out 1
R1
On / Off Heating
Channel A
EV 1
Channel A
Out 2
R2
On / Off Cooling
EV 2
Out 3
R3
FanCoil speed 1
Channel B
EV 3
Channel B
Out 4
R4
FanCoil speed 2
EV 4
Out 5
R5
FanCoil speed 3
Channel C
EV 5
Channel C
Out 6
R6 -
EV
6
Out 7
R7 -
Channel D
EV 7
Channel D
Out 8
R8 -
EV
8
The physical address, group address and parameters are assigned and programmed with ETS tool
software. In order to commission the device, a PC with ETS2 version V1.3 or higher is required as
well as an interface to the bus, (RS232, USB, etc...)