Edmunds Gages Accu-Setter II, User Manual

Page: 87 / 119

4-2
Output Pin Selection Jumper
The electronic signal from the A/E transducer may be output to another Accusetter II or
to an external device connected to the analog buss. The pin on which the signal is output,
from 1 to 6, can be selected using the "A OUT" jumper. The "B OUT" jumper is not
used on the E9330 module.
To select an output pin position the "A OUT" jumper so that it is on the desired number
pin and the center pin in the three pin group. For example, to output the signal on pin 5
place the jumper on the pin below marked "5" and the center pin between the "5" and "6".
Any device connected to the analog buss can now access the signal from pin number 5.
The "A OUT" jumper only has to be set if the signal is to be bussed to another column. If
the signal is not to be output the jumper should be place on one pin only.
NOTE: To buss a signal from one Accusetter II to another connect an interface cable,
Edmunds #4550200, from the "Output" connector on the rear of one column to the
"Input" connector on the rear of the next column. Multiple columns can be connected in
this way.
See LVDT Module,
Input Jumper Setup below for information on inputting signals from
other columns.
Shown in idle position. Does not output signal to buss.
Figure 4.2 - Output Pin Jumper