Edgetech PORT LF, User Hardware Manual

Page: 64 / 79

SECTION 6: MAINTENANCE 6-16
PORT LF 0008595_REV_E
6.3.2 General Inspection and Replacement Schedule
This chart is for customer convenience and gives general guidelines for inspection and suspected
replacement times for key parts. Regular inspections and cleaning are vital and should be done in tandem.
Table 6-1: General Inspection and Replacement Schedule
6.4 Common Spares
Common spares for the PORT-LF Unit are listed below along with their EdgeTech part numbers:
QTY DESCRIPTION EDGETECH MTL NUMBER
2 Screw, 10-32 x 1”, PH, Nylon MTL 34
1 Block, anti-rotation MTL 33
2 Anode, activated aluminum, 1” diameter ¼ - 20 MTL 29
1 Release Link MTL 32
1 Battery, Alkaline, PORT-LF MTL 45
2 O-ring, 2-240, N70 MTL 44
2 Back-up ring, 8-240, N90 MTL 43
1 O-ring, 10 x 14 x 2 mm, N70 MTL 18
2 O-ring, 2-008, N70 MTL 31
2 Closure strip, Kynar MTL 57
1 Assembly, purge port MTL 30
Table 6-2: Common Spares Refer to 0008118
6.5 Callout Assembly Drawings
Part Callout Assembly drawings for the PORT-LF are on the following pages:
PART SERVICE / INSPECTION REPLACEMENT NOTES
O-ring
Before and After Each
Deployment
As needed
Any questionable O-ring should be immediately replaced.
EdgeTech recommends the use of
Parker’s Super O-lube
silicone compound grease.
Battery Pack Before Each Deployment As needed
Release Link
Before and After Each
Deployment
Per release
Sacrificial part; can be recovered with assembly when using
tandem kit.
Release Shaft
O-Ring
As needed Check after 3-5 years Contact
EdgeTech C
USTOMER
S
ERVICE
for replacement
Anodes (2) After Each Deployment As needed
Anti-Rotation
Block Before and After Each
Deployment Should not be
needed