Edgetech PORT LF, User Hardware Manual

Page: 16 / 79

xvi
PORT LF 0008595_REV_E
Figure 6-7: Gently Guide the Transducer End Cap into the Housing without the Aluminum Band .......... 6-5
Figure 6-8: The Proper Alignment of the Transducer Orientation Key ...................................................... 6-6
Figure 6-9: Firm, Gentle Pressure will secure the End Cap to the Housing ............................................... 6-6
Figure 6-10: Insert the Kynar Rod into the Slot ......................................................................................... 6-7
Figure 6-11: The Proper Orientation of the Kynar Retention Rod ............................................................. 6-7
Figure 6-12: The Transducer Cable Connected to the JP1 Header Connector .......................................... 6-8
Figure 6-13: Unplug the Transducer Cable from the JP1 Header Connector .......................................... 6-10
Figure 6-14: The Battery Pack is on the underside of the Electronics Chassis ........................................ 6-10
Figure 6-15: The Retainer Brackets holding the Battery to the Electronics Chassis ................................ 6-10
Figure 6-16: The proper wire orientation for the PORT-LF battery pack ................................................. 6-11
Figure 6-17: Electronics Chassis Without the Battery Pack ..................................................................... 6-11
Figure 6-18: Install the New Battery Pack ................................................................................................ 6-12
Figure 6-19: The Hardware for one Bracket ............................................................................................ 6-12
Figure 6-20: The Transducer Cable Connected to the Electronics Board ................................................ 6-13
Figure 6-21: The Release End Cap O-rings ............................................................................................... 6-14
Figure 6-22: The Transducer End Cap O-rings ......................................................................................... 6-14
Figure 6-23: Cross Section of Round and Back-up O-rings ...................................................................... 6-15
Figure 6-24: PORT LF Callout Assembly Drawing Page 1 of 2 0008118 ................................................... 6-17
Figure 6-25: PORT LF Callout Assembly Drawing Page 2 of 2 - 0008118 ................................................. 6-18
Appendix Figure B-1: Remote Release - 0012120 ...................................................................................... B-2
Appendix Figure B-2: PORT LF Optional Remote Release - 0012266 ......................................................... B-3
Appendix Figure B-3: PORT LF Optional Remote Release Callout - 0007639 ............................................ B-4
Appendix Figure C-1: Optional Tandem Kit Diagram - 0017625 ................................................................ C-2
Appendix Figure C-2: PORT LF Optional Tandem Kit Callout Diagram - 0008237 ..................................... C-3
Appendix Figure D-1: PORT LF Optional Strongback Diagram - 0017674 ................................................. D-2
Appendix Figure D-2: PORT LF Optional Strongback Kit Callout Diagram - 0008166 ............................... D-3