Edge-Core ES4524M-PoE, Management Manual, Page: 522 / 560

Command Line Interface
4-252
4
Multicast Filtering Commands
This switch uses IGMP (Internet Group Management Protocol) to query for any
attached hosts that want to receive a specific multicast service. It identifies the ports
containing hosts requesting a service and sends data out to those ports only. It then
propagates the service request up to any neighboring multicast switch/router to
ensure that it will continue to receive the multicast service.
IGMP Snooping Commands
This section describes commands used to configure IGMP snooping on the switch
Table 3-8 Multicast Filtering Commands
Command Groups Function Page
IGMP Snooping Configures multicast groups via IGMP snooping or static assignment,
sets the IGMP version, displays current snooping and query settings,
and displays the multicast service and group members
4-252
IGMP Query Configures IGMP query parameters for multicast filtering 4-256
Static Multicast Routing Configures static multicast router ports 4-260
Multicast VLAN Registration Configures a single network-wide multicast VLAN shared by hosts
residing in other standard or private VLAN groups, preserving
security and data isolation for normal traffic
4-261
Table 3-9 IGMP Snooping Commands
Command Function Mode Page
ip igmp snooping Enables IGMP snooping GC 4-253
ip igmp snooping vlan static Adds an interface as a member of a multicast group GC 4-253
ip igmp snooping version Configures the IGMP version for snooping GC 4-254
ip igmp snooping
immediate-leave
Immediately deletes a member port of a multicast service if
a leave packet is received at that port and immediate-leave
is enabled for the parent VLAN
IC 4-254
show ip igmp snooping Shows the IGMP snooping and query configuration PE 4-255
show mac-address-table
multicast
Shows the IGMP snooping MAC multicast list PE 4-256