Edge-Core ES4524M-PoE, Management Manual, Page: 324 / 560

Command Line Interface
4-54
4
Note: Cluster Member switches can be managed through only using a Telnet connection
to the Commander. From the Commander CLI prompt, use the “rcommand”
command (see page 4-56) to connect to the Member switch.
cluster
This command enables clustering on the switch. Use the no form to disable
clustering.
Syntax
[ no ] cluster
Default Setting
Enabled
Command Mode
Global Configuration
Command Usage
• To create a switch cluster, first be sure that clustering is enabled on the switch
(the default is enabled), then set the switch as a Cluster Commander. Set a
Cluster IP Pool that does not conflict with any other IP subnets in the network.
Cluster IP addresses are assigned to switches when they become Members
and are used for communication between Member switches and the
Commander.
• Switch clusters are limited to a single IP subnet (Layer 2 domain).
• A switch can only be a Member of one cluster.
• Configured switch clusters are maintained across power resets and network
changes.
Example
cluster commander
This command enables the switch as a cluster Commander. Use the no form to
disable the switch as cluster Commander.
Syntax
[ no ] cluster commander
Default Setting
Disabled
Command Mode
Global Configuration
Console(config)#cluster
Console(config)#