Edge-Core ES4524M-PoE, Management Manual, Page: 309 / 560

System Management Commands
4-39
4
Event Logging Commands
This section describes commands used to configure event logging on the switch
logging on
This command controls logging of error messages, sending debug or error
messages to a logging process. The
no form disables the logging process.
Syntax
[ no ] logging on
Default Setting
None
Command Mode
Global Configuration
Command Usage
The logging process controls error messages saved to switch memory or sent
to remote syslog servers. You can use the
logging history command to
control the type of error messages that are stored in memory. You can use the
logging trap command to control the type of error messages that are sent to
specified syslog servers.
Example
Related Commands
logging history (4-40)
logging trap (4-42)
clear log (4-42)
Table 4-13 Event Logging Commands
Command Function Mode Page
logging on Controls logging of error messages GC 4-39
logging history Limits syslog messages saved to switch memory based on
severity
GC 4-40
logging host Adds a syslog server host IP address that will receive logging
messages
GC 4-41
logging facility Sets the facility type for remote logging of syslog messages GC 4-41
logging trap Limits syslog messages saved to a remote server based on
severity
GC 4-42
clear log Clears messages from the logging buffer PE 4-42
show logging Displays the state of logging PE 4-43
show log Displays log messages PE 4-44
Console(config)#logging on
Console(config)#