Edge-Core ES4524M-PoE, Management Manual, Page: 488 / 560

Command Line Interface
4-218
4
objects, and to increase the probability that multiple, rather than single
changes, are reported in each transmission.
• This attribute must comply with the following rule:
(4 * tx-delay)
≤
refresh-interval
Example
lldp admin-status
This command enables LLDP transmit, receive, or transmit and receive mode on the
specified port. Use the
no form to restore the default setting.
Syntax
lldp admin-status { rx-only | tx-only | tx-rx }
no lldp admin-status
• rx-only - Only receive LLDP PDUs.
• tx-only - Only transmit LLDP PDUs.
• tx-rx - Both transmit and receive LLDP Protocol Data Units (PDUs).
Default Setting
tx-rx
Command Mode
Interface Configuration (Ethernet, Port Channel)
Example
lldp notification
This command enables the transmission of SNMP trap notifications about LLDP
changes. Use the
no form to restore the default setting.
Syntax
[ no ] lldp notification
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Console(config)#lldp tx-delay 10
Console(config)#
Console(config)#interface eth 1/1
Console(config-if)#lldp transmit-and-receive
Console(config-if)#