Edge-Core ES3510MA-DC, Management Manual, Page: 999 / 1098

C
HAPTER
40
| CFM Commands
– 999 –
ethernet cfm delay-
measure two-way
This command sends periodic delay-measure requests to a specified MEP
within a maintenance association.
S
YNTAX
ethernet cfm delay-measure two-way [ src-mep source - mpid ]
{ dest-mep destination - mpid | mac-address } md domain-name
ma ma-name [ count transmit-count ] [ interval interval ]
[ size packet-size ] [ timeout timeout ]
source - mpid – The identifier of a source MEP that will send the
delay-measure message. (Range: 1-8191)
destination - mpid – The identifier of a remote MEP that is the target
of the delay-measure message. (Range: 1-8191)
mac-address – MAC address of a remote MEP that is the target of
the delay-measure message. This address can be entered in either
of the following formats: xx-xx-xx-xx-xx-xx or xxxxxxxxxxxx
domain-name – Domain name. (Range: 1-43 alphanumeric
characters)
ma-name – Maintenance association name. (Range: 1-45
alphanumeric characters)
count – The number of times to retry sending the message if no
response is received before the specified timeout. (Range: 1-5)
interval – The transmission delay between delay-measure
messages. (Range: 1-5 seconds)
packet-size – The size of the delay-measure message.
(Range: 64-1518 bytes)
timeout - The timeout to wait for a response. (Range: 1-5 seconds)
D
EFAULT
S
ETTING
Count: 5
Interval: 1 second
Table 145: show fault-notify-generator - display description
Field Description
MD Name The maintenance domain for this entry.
MA Name The maintenance association for this entry.
Hihest Defect The highest defect that will generate a fault alarm. (This is disabled
by default.)
Lowest Alarm The lowest defect that will generate a fault alarm (see the mep fault-
notify lowest-priority command).
Alarm Time The time a defect must exist before a fault alarm is issued (see the
mep fault-notify alarm-time , command).
Reset Time The time after a fault alarm has been issued, and no defect exists,
before another fault alarm can be issued (see the mep fault-notify
reset-time command).