Edge-Core ES3510MA-DC, Management Manual, Page: 710 / 1098

C
HAPTER
26
| Access Control Lists
MAC ACLs
– 710 –
MAC ACL
S
The commands in this section configure ACLs based on hardware
addresses, packet format, and Ethernet type. To configure MAC ACLs, first
create an access list containing the required permit or deny rules, and then
bind the access list to one or more ports.
access-list mac
This command adds a MAC access list and enters MAC ACL configuration
mode. Use the no form to remove the specified ACL.
S
YNTAX
[ no ] access-list mac acl-name
acl-name – Name of the ACL. (Maximum length: 16 characters, no
spaces or other special characters)
D
EFAULT
S
ETTING
None
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
◆
When you create a new ACL or enter configuration mode for an existing
ACL, use the permit or deny command to add new rules to the bottom
of the list.
◆
To remove a rule, use the no permit or no deny command followed by
the exact text of a previously configured rule.
◆
An ACL can contain up to 128 rules.
E
XAMPLE
Console(config)#access-list mac jerry
Console(config-mac-acl)#
Table 87: MAC ACL Commands
Command Function Mode
access-list mac Creates a MAC ACL and enters configuration mode GC
permit, deny Filters packets matching a specified source and
destination address, packet format, and Ethernet type
MAC-ACL
mac access-group Binds a MAC ACL to a port IC
show mac access-group Shows port assignments for MAC ACLs PE
show mac access-list Displays the rules for configured MAC ACLs PE