Edge-Core ECS4110-28T, Management Manual, Page: 219 / 1514

C
HAPTER
6
| VLAN Configuration
IEEE 802.1Q Tunneling
– 219 –
The preceding example sets the SVID to 99 in the outer tag for egress
packets exiting port 1 when the packet’s CVID is 2. For a more detailed
example, see the switchport dot1q-tunnel service match cvid command.
A
DDING AN
I
NTERFACE
TO A
Q
IN
Q T
UNNEL
Follow the guidelines in the preceding section to set up a QinQ tunnel on
the switch. Then use the VLAN > Tunnel (Configure Interface) page to set
the tunnel mode for any participating interface.
CLI R
EFERENCES
◆
"Configuring IEEE 802.1Q Tunneling" on page 1165
C
OMMAND
U
SAGE
◆
Use the Configure Global page to set the switch to QinQ mode before
configuring a tunnel access port or tunnel uplink port (see "Enabling
QinQ Tunneling on the Switch" on page 216 ). Also set the Tag Protocol
Identifier (TPID) value of the tunnel access port if the attached client is
using a nonstandard 2-byte ethertype to identify 802.1Q tagged
frames.
◆
Then use the Configure Interface page to set the access interface on
the edge switch to Access mode, and set the uplink interface on the
switch attached to the service provider network to Uplink mode.
P
ARAMETERS
These parameters are displayed:
◆
Interface – Displays a list of ports or trunks.
◆
Port – Port Identifier. (Range: 1-28/52)
◆
Trunk – Trunk Identifier. (Range: 1-16)
◆
Mode – Sets the VLAN membership mode of the port.
■
None – The port operates in its normal VLAN mode. (This is the
default.)
■
Access – Configures QinQ tunneling for a client access port to
segregate and preserve customer VLAN IDs for traffic crossing the
service provider network.
■
Uplink – Configures QinQ tunneling for an uplink port to another
device within the service provider network.
W
EB
I
NTERFACE
To add an interface to a QinQ tunnel:
1.
Click VLAN, Tunnel.
2.
Select Configure Interface from the Step list.
3.
Set the mode for any tunnel access port to Access and the tunnel uplink
port to Uplink.